Why added air can change the measured size of vape aerosol particles
Read where a lab adds air before sizing vape aerosol and why a concentration correction cannot restore droplets that evaporated.
No Vape · Updated

Find the air added before the measurement
Mikheev and colleagues describe clean air added along the sampling path before their instruments measured the aerosol. They also ran a separate high-dilution check by engaging an additional dilution stage in one instrument. The reported distributions changed under that condition, and the pattern differed between the two generation setups. In the limitations section, they also say that the dilution used in their main measurements could have allowed some evaporation. Look for both locations in the paper. A supplemental high-dilution figure describes a different condition from the main sizing results.
Use a dilution factor for the quantity it belongs to
Suppose a fictional measurement adds nine equal portions of particle-free air to one portion of aerosol. If every particle remained detectable and unchanged and the mixture were uniform, the particle count per unit of air in that mixture would be one tenth of the starting concentration. The original diameter of each particle would stay the same under those assumptions. Now imagine the droplets lose liquid after mixing. The same air ratio still describes the amount of air added, but it gives no record of how much any droplet lost. Scaling the count axis by ten cannot move each detected particle back into its original diameter bin. No values here come from an aerosol test.
Decide whether two curves answer the same question
Set the two captions side by side. For each curve, identify the point where air entered, whether extra dilution was turned on and the diameter definition the instrument reports. If a chart caption omits one of these details, check the methods or keep the comparison conditional. An honest summary might say that the two curves were measured after different sample conditioning, so you cannot assign the difference to the tested products alone. Two studies with the same clean-air ratio can still use different delivery paths or take different amounts of time to reach the instrument. Preserve those differences if the reports describe them.
This comparison is about the state of aerosol when it reached a laboratory instrument. It does not identify the particles that reach someone in an ordinary room, quantify personal exposure or tell you how to operate a device.
Sources and scope
Sources inform the guidance. The worksheets and examples are No Vape editorial suggestions, not tested treatments.
Written with AI assistance and checked against the cited sources. No clinical review is claimed. This guide covers practical planning, not individual medical treatment. How we research and write